Data Domain Cli Commands
Data Domain Cli Commands. The next command is probably my new favorite command to show data domain boost statistics in real time. Monospace bold commands the user types at the command prompt (#).
We can find the domain name of a computer by running the following commnad from command line. A log entry appears for each data domain system command given on the system. To set up the replication run the following command on both the source and target dd systems.
The Next Command Is Probably My New Favorite Command To Show Data Domain Boost Statistics In Real Time.
Preface as part of an effort to improve the product lines, revisions of the software and hardware are periodically released. Monospace bold commands the user types at the command prompt (#). References to data domain systems in this documentation, in the ui, and elsewhere in the product include powerprotect dd systems and older data domain systems.
Data Domain Boost Is A Set Of Capabilities For Products Outside The.
For the ha system, verify the health of the ha configuration, run the following command in cli: As of initial releases of this functionality is can only be configured via the data domain command line shell (ddsh) and cannot yet be configured via any graphical user. We can find the domain name of a computer by running the following commnad from command line.
Therefore, Some Functions That Are Described In This Document Might.
The best way to do it would be to mount /ddvar and run commands against the logs. Use the config command to manage the data domain system configuration settings. Data domain cli command reference.
A Log Entry Appears For Each Data Domain System Command Given On The System.
L emc data domain operating system command reference guide l emc data domain hardware guide l emc data domain expansion shelf hardware guide. For ha systems, run the # ha offline command if the system is in a highly available. Data domain systems can send network log messages to other systems enabled to listen.
The Dd System Primarily Receives Data, But It Can Also Send Data When Doing Restores Or Being The Source For Replication.
Find domain name from command line. To set up the replication run the following command on both the source and target dd systems. Most of the time, the iperf program runs on the dd.
Post a Comment for "Data Domain Cli Commands"